|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
OK?..manual is complet and helpfull... for repairing such a old and rare boombox like JVC PCM it is necessary...
;
Super Anleitung. Ordentliche Auflösung. Das ganze noch in Deutsch wäre zu schön. Alle Datenblätter sind sauber Kopiert und alle Leitungswege sind sauber ausgeführt
;
Thanks God for the internet and thanks for the service like this - proffessional solution on time.
;
About the service it's very fast and reliable. About the manual the quality is high enough to read even the tiniest details on the wiring diagrams so you can't ask much more than that, let it alone for a manual of a product from 20 years ago. Thank you, very satisfied.
;
The downloaded quality was as good as the orignial
DECK MECHANISM DISASSEMB Y L
17. Gear Cam L/ (Fig. B-17) D
1) Remove the Cam Bracket Assembly. 2) Remove the Gear Cam L/D.
19. Gear Assembly P2/P (Fig. B-19) 3
1) Remove the Plate Slider. 2) Remove by pushing one hook(B) on the top side of Gear Assembly P3. 3) Remove by pushing one hook(A) on the top side of Gear Assembly P2.
NOTE
1) When assembling the Gear Cam L/D, the groove ( ) of Plate Slider should coincide with to the groove ( ) on the Gear Cam L/D.
NOTES:
When disassembling and reassembling: a. The P2 and P3 Gear Assembly should not be interchanged. b. The groove( ) of Gear P2 should be aligned to the groove( ) of Gear P3. c. Set the hole of Lever to the Boss of P2 and P3 Base Assembly. (When assembling make sure that the Lever is not bent.)
CAM Bracket
Gear CAM L/D
GEAR P3
GEAR P2
(A)
(B) Lever
Fig. B-17 Gear Cam L/D
BOSS
18. Gear PS/Plate Slide (Fig. B-18) r
1) Remove two washers(C). 2) Remove the Plate Slider. 3) Remove the Gear PS.
BOSS
Fig. B-19 Gear Assembly P2/P3 NOTE
1) When the hole(A) of the Gear PS is aligned to the hole(B) of the chassis, the groove( ) of the Plate Slider should be aligned to the groove( ) of the Gear PS.
20. Base Assembly P2/P (Fig. B-20) 3
1) Remove the P2/P3 Gear Assembly. 2) Remove the P2/P3 Base Assembly.
(C) BASE P2
BASE P3
(A) Gear PS
(C) Plate Slider
(B)
Fig. B-18 Gear PS/Plate Slider
Fig. B-20 Base Assembly P2/P3
4-10
|
|
|
> |
|
